Bonding bridges, adhesives and mortarsMortars

Morterplus Elastic

Elastic waterproofing mortar. Tileable

Two-component elastic cementitious waterproofer.

Morterplus Elastic

The product

Morterplus Elástic is a two-component cementitious waterproofer with high adhesion and flexibility, formulated on the basis of high-quality waterproof mortar and unsaponifiable resins of high elasticity, specifically designed for the waterproofing of all types of substrates prior to their cladding, intended to contain drinking water or in the rehabilitation and repair of areas affected by moisture.

Due to its optimal formulation and cementitious base, once cross-linked it is fully trafficable, resistant to traction, and durable against weathering. In addition, the high quality of the resin used gives it a unique flexibility, so the material, as well as being watertight, does not crack.

It can be used even in the presence of moisture. Unlike other waterproofing products, the composition and adhesion of the product allow it to adhere to all types of absorbent substrates, even when damp.

Versatile, in addition to the characteristics described above, it has high resistance to UV rays and climatic agents. All of these make the product suitable for use both as a finishing layer, as a prior layer for cladding, or in grouting work. Furthermore, its fine roughness provides a high-quality non-slip finish.

Morterplus Elástic is a completely safe product for both the operator and the end user. On the one hand, it is formulated without solvents, so the product does not emit odours or VOCs, and on the other hand, it is suitable for waterproofing cisterns or tanks intended to contain drinking water.

  • Suitable for drinking water.
  • Excellent adhesion.
  • High elasticity.
  • Great resistance.
  • Long durability.

Morterplus Elastic

Applications

Given the versatility of Morterplus Elástic, it can be used in all types of waterproofing work where high trafficability, adhesion, resistance, and elasticity are required.

- Typical examples of its use are: waterproofing of concrete walls, terraces, balconies, under shower trays, construction of swimming pools prior to tiling, waterproofing of lift pits or coating of cisterns or tanks, among others.

Morterplus Elastic

Application method

Morterplus Elástic is a two-component product that must be mixed before application. Surfaces must be consolidated, clean, and free of oil, grease, dust, or substances that could hinder the adhesion of cementitious products. Morterplus Elástic shows high adhesion on damp surfaces; application on wet surfaces is not possible (r.h. > 35%). If the substrate has a moisture content below 10%, it is recommended to dampen it with water beforehand.

Initially, mix components A and B in the supplied ratio (2 parts dry mortar to 1 part emulsion resin) until a homogeneous, lump-free mixture is obtained, using a mechanical mixer at low speed.

Next, allow the mixture to rest for a few minutes and briefly mix again.

Then apply the product at the desired thickness, not exceeding 2 mm per coat. Application can be carried out using a trowel or spatula, and it can also be applied with a brush by adding more emulsion resin.

Finally, allow the product to dry for 48 hours, protecting it if rain is expected within 24 hours of application.

Morterplus Elastic

Technical data

MIXING DENSITYpHYIELDMIXING TIMEWORKABILITY TIMEAPPLICABLE THICKNESSESINTERVAL BETWEEN COATS
Approx. 1.4 g/cm38.0 ± 0.51.5 Kg/m2 per mm of thickness.Approx. 5 min.Approx. 1 hourFrom 1 to 2 mm per coat.12/24 Hours

Need advice about this product?

Contact our technical team to select the right product.

Request advice
Neoquimito
Neoquimito Neoquimito