Protective, regenerative or special treatments · Consolidating treatments
Protective, regenerative or special treatmentsConsolidating treatments
Instant mortar setting accelerator mineralizer
Mineralizer and hardener for mortars. Setting accelerator for cementitious mixes.
MINERAL FORTE
Is a dual-action product, based on a synergistic mixture of reactive inorganic compounds, designed to, on one hand, seal, waterproof and mineralize mortar and concrete surfaces both in fresh and hardened states and, on the other hand, accelerate the setting of cementitious mixes intended for plugging water leaks, or for rendering work that requires immediate commissioning.
Thus, Mineral Forte, applied to mortar or concrete surfaces, chemically fills capillary porosity through a chemical reaction between its components and the lime in the cement. Thanks to this mode of action, the porosity reduces its diameter and the surface acquires waterproof properties. This quality allows Mineral Forte to create a highly effective barrier against moisture in floors with capillary water presence in a quick and simple manner. Additionally, its consolidating action causes an improvement in the mechanical and chemical resistance of treated mortars and concretes, while also causing a strong reduction in dust formation on mortar and concrete floors that have not been sealed, keeping them clean for longer. Mineral Forte is also fully recommended for accelerating the setting of mortars intended for the repair and plugging of surfaces presenting water leaks. Due to its high reactivity with cement components, Mineral Forte added to the mixing water of cement or mortar generates rapid hardening of the latter without reducing its adhesion, allowing any crack or water leak to be plugged within a few minutes, without the need to dry the area.
Is a high-yield product, making it very economical in use. Thus, 1 L of product is sufficient to seal and consolidate 3 to 6 m2 of surface in a quick, easy and professional manner.
MINERAL FORTE
Mineral Forte is especially recommended for use in all types of situations where it is desired to reduce dust formation, consolidate, seal or waterproof mortar or concrete slabs by reducing their porosity and, additionally, improve their resistance both in new construction and in renovation, or to repair cracks, fissures or water leaks in already-built surfaces in a quick and permanent manner.
MINERAL FORTE
Before applying Mineral Forte it is recommended that the surface be completely clean, cohesive and free of treatments that may hinder the correct performance of the product.
Use as a sealer, waterproofer, hardener and dust-proof treatment:
Initially, moisten the surface to be treated with water. Then, apply Mineral Forte neat or diluted with up to 3 parts of water (depending on the porosity and absorption of the surface). It can be applied using a brush, roller or even low-pressure spraying. (Optionally, in cases where there is a high presence of capillary moisture and/or when it is desired to smooth the surface, dust the treated area with powdered cement, applied using circular movements, followed by smoothing with a sponge). Finally, allow to dry for 2–3 hours, removing the excess partially gelled unabsorbed product. After 24 hours from application, a water rinse can be carried out to obtain a surface fully ready for commissioning.
Repair of cracks and plugging of water leaks:
Initially, mix 2 parts of powdered cement or mortar with 1 part of Mineral Forte. Then, knead until a consistent putty is obtained. Next, press the paste into the water leak or crack, applying pressure and maintaining it for 1–2 minutes. Finally, allow to harden completely and regularize the surface according to the desired finish.
MINERAL FORTE
| Reference | Appearance | Density | pH | Viscosity | Yield | Composition |
|---|---|---|---|---|---|---|
| Mineral Forte | Yellowish translucent liquid | 1,28 ± 0,01kg/L | 12.0 ± 0,5 | < 200 cP | 3 – 6 m2/L | Reactive inorganic compounds |
Contact our technical team to select the right product.