Bonding bridges, adhesives and mortarsMortars
MORTERPLUS REPAR
Repair mortar. Coarse finish. High thickness
R3 repair mortar for concrete and mortar surfaces.
MORTERPLUS REPAR
The product
Is a class R3 repair mortar according to EN-1504-3, developed on the basis of special cements, selected aggregates, state-of-the-art additives, and reinforced with fibres.
Has excellent adhesion to concrete, compensated shrinkage and high thixotropy, which respectively produces finishes of high durability, free of cracks and without sagging. Likewise, the hardened product has high water vapour permeability, good resistance to chlorides, excellent resistance to freeze-thaw cycles and good weathering resistance.
Based on these properties, Morterplus Repar is especially recommended for the repair of structural elements such as: balcony edges, beams/columns of commercial and residential buildings, precast concrete panels, levelling of concrete surfaces, linings of channels, tunnels, bridge overhangs and balconies, or pavement repair, among others.
- Fibre-reinforced.
- Class R3 according to EN-1504-3.
- Thixotropic.
- Compensated shrinkage.
- High resistance to carbonation.
MORTERPLUS REPAR
Applications
Morterplus Repar should be used in those circumstances where it is necessary to repair mortar or concrete surfaces with a high-strength, compensated-shrinkage product, such as: columns, balcony edges, precast panels, overhangs, etc.
MORTERPLUS REPAR
Application method
Before applying Morterplus Repar, the following must be taken into account:
- The substrate must be sound, clean, free of grease, oils, dust and poorly adhered parts (minimum tensile strength of 1.5 MPa). If necessary, prepare the substrate preferably using mechanical means and expose the sound concrete.
- Absorbent substrates must be pre-wetted until saturated, avoiding ponding; apply the product once the surface takes on a matt appearance.
- If reinforcement bars are present, they must be clean of rust, grease, oils and other poorly adhered particles.
- If they are rusted, they must be cleaned by sandblasting or with a wire brush, protecting them from corrosion with Converox.
- At junctions between vertical and horizontal surfaces, widen the joint by cutting it to approximately 10 mm wide with an angle grinder, then remove the cut material.
To apply Morterplus Repar:
- Initially, add 2/3 of the planned water and progressively mix in all of the powder while stirring; then add the remaining water and mix for a further 2 minutes. (Do not prepare more material than will be used within 30 minutes.)
- Then apply Morterplus Repar with a trowel or by spray gun, pressing to ensure adhesion and to compact the material firmly. (Morterplus Repar can be applied in several layers, with a minimum thickness per layer of 5 mm.
On vertical surfaces, thicknesses of up to 35 mm can be applied without the aid of formwork.
On horizontal surfaces the maximum thickness is 75 mm. At junctions between vertical and horizontal surfaces, fill the full width of the joint completely.)
Need advice about this product?
Contact our technical team to select the right product.