Bonding bridges, adhesives and mortarsMortars
MORTERPLUS REPAR COSMETIC
Repair mortar. Fine finish. Low thickness
Cosmetic mortar for levelling and repairing surfaces.
MORTERPLUS REPAR COSMETIC
The product
Is a class R3 cosmetic repair mortar based on special cements, ultra-fine granulometry aggregates, additives and silica fume, specifically developed for the repair and levelling of surfaces commonly found in construction.
It has excellent adhesion and workability, allowing high-quality, low-roughness finishes to be achieved. These properties give the product optimal docility for reshaping tasks.
The low granulometry of its aggregates allows the sealing of porosity in concrete and mortar substrates. Likewise, its good compatibility with concrete and its high resistance to water and weathering facilitates the regularisation of concrete or mortar surfaces without loss of properties over time.
Thanks to these properties, it is especially recommended for the repair and levelling of damaged concrete and mortar surfaces in structures, pillars, facades, prefabricated elements… etc. As well as in the application of fine renders.
- Class R3 according to EN-1504-3..
- Ultra-fine granulometry.
- Thicknesses of up to 5 mm.
- Excellent adhesion.
- Optimal workability and finish.
MORTERPLUS REPAR COSMETIC
Applications
Morterplus Repar Cosmetic can be used in the repair, levelling and finishing of all types of mortar and concrete surfaces where an ultra-fine finish and a thickness of less than 5 mm are required.
MORTERPLUS REPAR COSMETIC
Application method
Before applying Morterplus Repar Cosmetic, ensure that the substrates are stable, sound, clean, free of dust, release agent residues, organic products and poorly adhered parts.
Absorbent substrates shall be pre-wetted until saturated, avoiding ponding.
To apply Morterplus Repar Cosmetic:
- Initially add 2/3 of the planned water (5.5 l–6 l) and progressively mix in all of the powder while stirring.
- Then add the remaining water and mix for a further 2 minutes. Do not prepare more material than will be used within 30 minutes (at +20 ºC).
- Finally, apply Morterplus Repar Cosmetic with a trowel or spatula in layers of 2 to 5 mm.
- Before applying the final finish, allow to partially set.-Then apply Morterplus Repar with a trowel or by spray gun, pressing to ensure adhesion and to compact the material firmly. (Morterplus Repar can be applied in several layers, with a minimum thickness per layer of 5 mm. On vertical surfaces thicknesses of up to 35 mm can be applied without the aid of formwork. On horizontal surfaces the maximum thickness is 75 mm. At junctions of vertical and horizontal surfaces, fill the full width of the joint completely).
Need advice about this product?
Contact our technical team to select the right product.