Putties and Sealants

CINTA SILENCIADORA

Self-adhesive tape with metallic protection for soundproofing manhole covers

Self-adhesive tape for soundproofing manhole covers.

Physical state
Solid

CINTA SILENCIADORA

The product

CINTA SILENCIADORA GRIS is a self-adhesive waterproofing strip with metallic self-protection, specially designed for the soundproofing of manhole covers and gully grates. It allows sealing work to be carried out and reduces the metallic noise associated with the contact points between the cover and its seating. It is composed of an SBS-modified bituminous mastic, protected on its upper face by a smooth aluminium sheet in a lead-grey colour. The lower face incorporates a non-stick plastic film that is removed when the tape is applied, exposing the adhesive surface. The combination of the mastic and the aluminium protection provides a strip intended for sealing and for the reduction of noise and moisture. Its roll format facilitates cutting of the required lengths and allows the length of each piece to be adapted to the surface to be treated. Application is carried out by pressing onto clean, dry substrates, without preparing mixtures. Correct preparation of the seating and firm pressure during installation are essential to achieve good adhesion. When the substrate is irregular or in poor condition, it is recommended to apply a suitable primer beforehand. The product is aimed at maintenance interventions where the goal is to improve seating and reduce noisy contact between elements. The result depends on the condition of the assembly, the surface available for adhering the tape, and the correct execution of the work.
  • Reduces metallic noise.
  • Long-lasting protection.
  • Easy application.
  • Non-hazardous.

CINTA SILENCIADORA

Applications

Specially indicated for the soundproofing of manhole covers and gully grates. Suitable for sealing work where a self-adhesive strip with metallic protection and waterproofing action is required. Its use allows action to be taken at bearing and contact points that generate metallic noise. Check the condition of the cover and frame beforehand, as well as the suitability of the substrate for application.

CINTA SILENCIADORA

Application method

Substrate preparation: Substrates must be clean and dry. Remove loose materials and residues that may hinder adhesion. If the substrate is not homogeneous or is in poor condition, apply a suitable primer beforehand. Tape installation: Cut the length required to cover the contact or sealing area. Remove the non-stick film from the lower face and place the tape on the prepared substrate, pressing firmly over its entire surface. Checking and maintenance: Verify adhesion and the correct seating of the cover. The tape must be placed without preventing the proper closure or seating of the assembly. Periodically check its condition during routine maintenance tasks. Keep out of reach of children and store away from heat sources. Keep the non-stick film in place until the moment of use. Consult the label instructions before applying. The softening point and flexibility values correspond to characteristics of the material and must not be interpreted as a service temperature range.

CINTA SILENCIADORA

Technical data

Softening point
100 °C
Penetration (25 °C, 5 s, 100 g)
55–75 (1/10 mm)
Mastic flexibility
−25 °C
Elongation and elastic recovery
Minimum 90 %
Colour
Lead grey
Self-protection
Smooth aluminium, 50 microns
Mass
1.5 kg/m²
Flow (2 h at 70 °C)
Does not flow
Flexibility at −20 °C
Does not crack
Tensile strength
120 N/5 cm
Peel resistance
100 N/5 cm

Formats

Rolls of 10 m long × 10 cm wide, presented in boxes of 4 rolls.
Physical state
Solid

Need advice about this product?

Contact our technical team to select the right product.

Request advice
Neoquimito
Neoquimito Neoquimito