Protective, regenerative or special treatments · Anti-stain treatments
Protective, regenerative or special treatmentsAnti-stain treatments
Water-based oleophobic and stain-resistant protector.
Anti-stain protector for porous surfaces. Water-based.
Protector Stone Aquo
Is a water-based anti-stain protector, formulated with high-quality oleo-repellent actives and wetting agents, which provides the surfaces to which it is applied with repellency against stains, preventing dirt from adhering strongly or penetrating by capillarity.
In this way, treated substrates are protected by a completely invisible, highly durable barrier that allows the material to "breathe" without modifying either the colour or the gloss of the surface, while preventing it from absorbing: oils, greases, sauces, coffee and other beverages, making cleaning easier and maintaining its original appearance for long periods of time without requiring any special maintenance to preserve its properties.
Protector Stone Aquo
Formulated on a water base, so it emits no odours and is safe for the applicator and end user. Thanks to this characteristic, it is suitable for application both indoors and outdoors and on all types of absorbent substrates, both natural and synthetic. It can also be applied even on substrates that contain a high degree of moisture, such as, for example, after carrying out a thorough cleaning. This feature makes it possible to optimise application costs, since it is not necessary for the substrate to be completely dry, as is the case with equivalent products containing organic solvents.
It also possesses water-repellent properties, so the protective barrier also retards the absorption of water. This characteristic reduces problems caused by water, such as the formation of salts and white efflorescence, the appearance of rust stains, the appearance of mould, etc.
Protector Stone Aquo is suitable for application on all types of absorbent surfaces on which oleo-repellent and anti-stain properties are desired.
For example: Marble, granite, terrazzo, limestones, concrete, microcement, etc.
Protector Stone Aquo
Protector Stone Aquo is a ready-to-use product and therefore requires no dilution before use.
Before applying the product, the surface must be thoroughly clean and, preferably dry or with a moisture level not exceeding 40%.
Next, apply the product with a brush, roller or by spraying, spreading it uniformly over the entire surface until correct saturation is achieved.
On highly porous materials it is recommended to apply two coats "wet on wet", leaving a maximum of 60 minutes between each application.
Finally, allow the product to act for a few hours until completely absorbed. The surface will be completely protected 24 hours after application.
In the event that the application of the product has been excessive in relation to the absorbent characteristics of the substrate, the surplus must be removed using a cloth slightly dampened with the same product within no more than 30-40 minutes.
Tools can be rinsed with water after use. For maintenance cleaning of protected surfaces, use a neutral pH cleaner-degreaser.
Protector Stone Aquo
| APPEARANCE | DENSITY | YIELD | COMPOSITION |
|---|---|---|---|
| Opaque beige-coloured liquid. | 1.001 ± 0.01 g/cm3 | Approx. 10 m2/L. | Oleo-repellent actives, wetting agents and adjuvants. |
Contact our technical team to select the right product.