Wet look water repellent for low porous surfaces.

HIDROSOL MG

Wet look water repellent for low porous surfaces.

  • Protects against problems caused by water.
  • It enhances the tone of the stone.
  • Improves wear resistance.
  • Allows the surface to breathe.
  • Ready to use.

Hidrosol mg is a water-repellent product, based on siloxanes and polysiloxanes in a solvent base, specifically created to protect all types of absorbent surfaces against problems caused by water, such as humidity, salt efflorescence, moulds and verdigris growth or the appearance of frost cracks, among others. In addition, Hidrosol MG positively contributes to reduce the heat
transmission coefficient of the treated wall, improving its thermal insulation capabilities.

Its well thought out resin-free composition provides a completely colourless and non-gloss water barrier, keeping the surface breathability intact. Once the product has been absorbed by the
surface, Hidrosol MG enhances its natural tone, giving it a moist appearance. This gives the surfaces a completely rejuvenated appearance with more vivid colours.

Hidrosol MG is suitable for all types of materials and absorbent surfaces, both vertical and horizontal with a slight slope (>3%), which together with its optimal resistance to abrasion and
UV rays, has excellent durability. In addition, since it does not contain any resins in its composition, it does not yellow, crack or peel over time and is 100% trafficable.

Application Areas

Hidrosol mg is the ideal product to use when it is necessary to protect low porosity surfaces against the action of water and give them a wet appearance simultaneously. For example:
polished marble and granite surfaces, slate, unglazed ceramic surfaces…etc.

Mode of Application

HYDROSOL MG is a ready to use product, so it does not need to be diluted before applying. Before applying Hidrosol MG, the surface must be completely clean, hardened and perfectly dry.
In addition, it must be absorbent, otherwise the treatment will not be effective, generating a sticky surface.

Then apply Hydrosol MG on the surface until it is fully saturated. This can be done by using: short hair roller, brush or low pressure spray.

Then, let the product be absorbed by the treated stone for 30 minutes. If after that time Hydrosol MG has not completely penetrated, remove the excess with the help of a cloth / absorbent
material.

Finally, let the treatment dry completely. After 24 hours the product is 100% effective. It is recommended to protect against condensation or rain within the first 24 hours of application.

Format

  • Metal containers of 1, 5, and 10 litres.
  • Plastic container of 30 litres.

Description

Product Sheet

See Sheet

Description

Product Sheet

See Sheet